= Job cards for GiBUU =

We use so-called "job cards" for passing input parameters to GiBUU. A job card is just a simple plain-text file which contains all these parameters, determining the setup of the simulation being performed (e.g. type of projectile and target, beam energy, number of runs, which analysis to perform, which output to generate, etc).

Before you go on studying the example job cards given below, please note the following:
 * Each job card consists of several "namelists". Each namelist contains input parameters for one specific module within GiBUU.
 * Text after an exclamation mark (!) is considered as a comment in a namelist
 * Some of the example files given below are not strictly conform with the Fortran 2003 standard (we use "$end" as ending and not "/", and we use "$" instead of "&"). So code compiled with some compilers might complain about our convention (if this is the case then please replace "$end" by "/" and "$" by "&").
 * Unless indicated otherwise, distances are given in ''fm'', Energies and momenta in ''GeV'' and hadronic cross sections in ''mb''. 

For detailed information on almost all possible namelists and its switches we refer to our [http://gibuu.physik.uni-giessen.de/Documentation/code/robo_namelist.html#top online namelist documentation]. 


== Examples ==
 1. [wiki:jobCards/omegaTaps TAPS]:
{{{
#!latex
$\gamma A\rightarrow\omega X$  @ 0.9-2.2 GeV
}}}
 2. [wiki:AnnotatedJobHarp Pion or proton induced reaction on nuclei in the energy regime of 3 to 50 GeV, as e.g. possible within the HARP and NA61/Shine experiments.]
 3. [wiki:jobCards/deuterium Jobcard switches for Deuterium targets]
 4. [wiki:jobcards/FOPI FOPI]:
{{{
#!latex
$\pi^-$A  @ 1.7 GeV
}}}
 5. [wiki:jobcards/ANKE ANKE]:
{{{
#!latex
pA  @ 2.83 GeV
}}}
 6. [wiki:jobcards/g7 CLAS/g7]:
{{{
#!latex
$\gamma A\rightarrow e^+e^-X$  @ 1-5 GeV
}}}
 7. [wiki:jobcards/jobPhotoProd High energy photon induced]: Using !HiLepton in the limit
{{{
#!latex
$Q^2\rightarrow 0$ GeV^2
}}}